abstract on electronic watchdog

   ELECTRONIC WATCHDOG

CIRCUIT OPERATION

                            The transmitter circuit shown in below fig.1 is built around timer NE555 (u1), which is wired as an astable multivibrator producing a frequency of about 38KHz. The infrared (IR) beam is transmitted through IR LED1. 

TRANSMITTER:

                                 The receiver circuit is as shown in fig.2 .It comprises IR sensor TSOP1738 (IR RX1), NPN transistor BC548 (Q1), timer NE555 and some resistors & capacitors. Timer is wired as a monostable multivibrator with a time period of around 30 seconds. The melody generator section is built around melody generator IC UM66, transistor (Q2) and loudspeaker.

                                  The power supply for the transmitter is derived from the receiver circuit by connecting its points A and B to the respective points of the receiver circuit. The receiver is powered by regulated 6V dc. For this purpose you can use a 6V battery.

RECEIVER:

                             The transmitter and receiver units are aligned such that the IR beam falls directly on the IR sensor. As long

The Best Essay Writing Service - EssayBox.org

as the IR beam falls on the sensor, its output remains low, transistor Q1 does not conduct trigger pin of IC remains high.

                                      When anyone interrupts IR the beam falling on the sensor, its output goes high to transistor Q1 into conduction and trigger pin of IC goes low momentarily. As a result, IC gets triggered its pin3 (output) goes high to supply 3.3V to melody generator IC at pin2, which produces a sweet melody through the speaker fitted inside the house. Output pin of 555 IC remains high for around 30 seconds.

APPLICTION:

The transmitter and receiver units are mounted on the both sides of the gate as shown in the figure.  

                 To achieve high directivity of the IR beam towards the sensor, use a reflector behind IR LED. When somebody enters through the gate or door the IR beam is interrupted and the alarm sounds for 30 seconds. The alarm keeps sounding as long as the one stands between transmitter and receiver units.

 This circuit can also be used as a doorbell or burglar alarm.   


Category: Abstract

Similar articles: